Engine-driven pumps Pramac MP56-3

What it is

Engine-driven pumps Pramac MP56-3. Key specifications: type Semitrash, maximum suction height (m) 8, total head (m) 26.

A dirty water pump is an electric pump or engine-driven pump that draws water containing mud, sand or solids from excavations, sumps, tanks and flooded rooms.

What it is for

Used for water drainage and for pumping water out of excavations, tanks and sumps.

How to use it

Lower the submersible pump to the lowest point, suspended by a rope attached to the handle (never by the cable), and rest it on firm ground; set the engine-driven pump on a level surface, prime it by filling the pump casing with water and immerse the suction hose with its strainer. Connect the delivery hose without kinks, start the pump and check that it does not run dry. After use, run it in clean water to flush it out.

Where it is used

• Agriculture
• Earthmoving and excavation
• Water engineering works

Technical data

• Type: Semitrash
• Maximum suction height (m): 8
• Total head (m): 26
• Max flow rate (l/min): 930
• Starting: Manual (self-retracting)
• Fuel: Petrol

Who it is for

Designed for plumbers and agricultural workers.

Related products

• Engine-driven pumps Pramac MP66-3
• Engine-driven pumps Pramac MP36-2
• Extendable watering hose — from the category Water Hoses and Layflat Hoses
• Generator SP12000 400V IP54 #AVR #IPP Pramac — from the category Portable and Wheeled Generating Sets
• Nautical braided rope — from the category Synthetic Ropes and Lines
• Browse the whole category: Electric and Engine-Driven Pumps for Dirty Water and Wastewater

Before you order

In your request, please state the rated load or flow rate and the quantities required, so we can give you the right quotation first time.

For prices and availability, request a quote from AMES Srl: we will reply with our quotation, delivery times and, where needed, an equivalent technical alternative.