Skip to content
0 Quotes 0Compare
All Pedrollo products

Submersible pump TRITUS-TX Pedrollo

Also known as: submersible pump

Code TRITUS-TX

Key features

  • CapacityUp to 90 l/min (5.4 m³/h)
  • Motor2-pole
  • Motor casingStainless steel AISI 304
  • HeadUp to 12 m
  • Liquid temperatureUp to +40 °C and up to +90 °C for short intervals (maximum 3 minutes) in intermittent duty
  • Maximum operating depthUp to 5 m (with a suitably long power cable)
See all 12 specifications

What it is

Electric pump TRITUS-TX Pedrollo. Key specifications: capacity Up to 90 l/min (5.4 m³/h), motor 2-pole, motor casing Stainless steel AISI 304.

A dirty water pump is an electric pump or engine-driven pump that draws water containing mud, sand or solids from excavations, sumps, tanks and flooded rooms.

What it is for

Used for water drainage and for pumping water out of excavations, tanks and sumps.

How to use it

Lower the submersible pump to the lowest point, suspended by a rope attached to the handle (never by the cable), and rest it on firm ground; set the engine-driven pump on a level surface, prime it by filling the pump casing with water and immerse the suction hose with its strainer. Connect the delivery hose without kinks, start the pump and check that it does not run dry. After use, run it in clean water to flush it out.

Where it is used

  • Water engineering works
  • Civil protection

Technical data

  • Capacity: Up to 90 l/min (5.4 m³/h)
  • Motor: 2-pole
  • Motor casing: Stainless steel AISI 304
  • Head: Up to 12 m
  • Maximum operating depth: Up to 5 m (with a suitably long power cable)
  • Bottom emptying level: Up to 35 mm
  • Protection: IP68
  • Pump body: Technopolymer
  • Impeller: Noryl™
  • Drive shaft: Stainless steel AISI 431
  • Grinder: Hardened AISI 440C stainless steel

Who it is for

Designed for plumbers.

Related products

Before you order

In your request, please state the rated load or flow rate and the quantities required, so we can give you the right quotation first time.

For prices and availability, request a quote from AMES Srl: we will reply with our quotation, delivery times and, where needed, an equivalent technical alternative.

Quantity
Specifications 12
CapacityUp to 90 l/min (5.4 m³/h)
Motor2-pole
Motor casingStainless steel AISI 304
HeadUp to 12 m
Liquid temperatureUp to +40 °C and up to +90 °C for short intervals (maximum 3 minutes) in intermittent duty
Maximum operating depthUp to 5 m (with a suitably long power cable)
Bottom emptying levelUp to 35 mm
ProtectionIP68
Pump bodyTechnopolymer
ImpellerNoryl™
Drive shaftStainless steel AISI 431
GrinderHardened AISI 440C stainless steel

The perfect setup for this job

Everything you need in one place, from functionality to safety.

For the job

For safety